Improvement #2: Create a Leveling pad dial.Ī dot on the leveling pads is useful. If you are going to be putting the Sharpie away, it's a good idea to replace the cap, particularly if storing in a pocket. (My expertise.) And, the next step, with which I have a little more is to point the tip to a specif place and plant the tip right on the object to be marked. The trick is to first take the cap off the Sharpie. And, being highly skilled in the use of Sharpies, that is the first thing that was done to improve the process. It's easier to see how far you have turned a wheel if it has a mark on it that you can track. Improvement #1: Apply a small Sharpie Dot on the magnetic pads :)Ĭompared with previous printers I've used, the Print Pad Leveling, using Auto Level is a fantastic improvement.īut, there is always room for improvement in processes. I'd just like to have a tab bit more manual control at times. ![]() And, I'm DEFINITELY enjoying its 70 micron precision. I've thoroughly enjoyed getting to know my Cube 3. It's like my 1st Gen Cube in that we have gotten to be good friends that understand each other. In fact, if someone were to approach me and offer to exchange this printer for an even newer one, I would turn them down. It is such a wonderful 3D printer, it deserves nothing less. But, right now, I could use a bit of added manual functionality to make this 3D printer absolutely perfect. And, on the most recent releases of Cube 3 machines, I am certain that is already the case. I fully expect to get to the place where Auto Level and Auto Gap work flawlessly every time. All we would need is up and down arrows for control. It would certainly make it easier to examine the setup of our printer more easily and quickly. It would be nice to have the ability to control the height of the Print Table as a single function, without it being connected to either Auto Level or Auto Gap. And, even then we face some time-out issues. ![]() While it can be done with Auto Gap, we must go though the Auto functionality completely before being able to manually control the Print Table height. ![]() Setting the ROLL on the Print Jet Housing is an iterative process. The print jets are deep within the structure of the Cube 3 and very difficult see without adding light from the front or back of the printer. With the Cube 2, the print jets were right out front and clearly visible. It takes time to examine ROLL and GAP on the Cube 3. Manual Print Plate Height Placement as a Single Control Function There are any number of things we could wish for as additional functions available through the touch screen display on the Cube 3.īut, having spent a lot of time seriously exploring LEVEL and GAP on the Cube 3, it is becoming clear that having one simple additional function stands out as a priority.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |